Plumbing Tips You Should Definitely Check Out

When it comes to plumbing, you want to make sure that you are getting the best advice available. Use the tips and tricks provided in this article to ensure that you are getting reliable information to use at home and it will not lead to further, unwanted costs down the road.

Use the sounds you hear from your pipes to help you to determine what they problem is. Certain sounds mean the water pressure is too high. Other sounds can signify loose pipes or slight clogs from calcium or iron build up. Listening to your pipes can save you a lot of money hunting down the problem.

Do not put cooking oils, fat, or grease, down your drain. These fats cause clogs by solidifying in pipes. To properly dispose of fats, put them in a bowl with a lid that you can dispose of. Once it gets hard, throw it in the trash or compost bin.

Make sure overflow holes are cleaned out. This can help to prevent any water damage. Overflow holes are a way to stop water from overflowing if a sink is left on by accident. If the overflow hole is clogged it will not be able to do its job.

Got a leaky pipe? In many cases you can repair this yourself without the expense of a plumber. If a joint is leaking, tighten it with a pipe wrench. If the leak is coming from a damaged section of pipe, you can try repairing with a store-bought patching kit. One method involves applying waterproof tape to the section of pipe where there is leakage. Before applying the tape, make sure the pipe is thoroughly dry. Make sure that the tape covers two to three inches on either side of the breakage in the pipe.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

Always keep your garbage disposal clean. You can do this in many ways. Pour some dish soap in and let the disposal run for a few minutes with some cold water. Be sure to run it regularly, if not, it can cause rust. To eliminate foul odors, grind lemon or other citrus peels. You can clean the walls of the disposal by grinding small fruit pits or egg shells.

If your drain in any device is taking longer to drain water, then you may need to have your pipes professionally cleaned depending on the severity of the circumstances. Before you do this, there are several different products you can try. However, some of them are professional strength and all products should be used with caution.

To avoid freezing pipes in the winter, make sure to insulate any exposed pipes in you basement before winter comes. Pay extra attention to pipes near the outside walls. If you have had a problem with any particular pipe freezing in the past, apply some heat tape to insulate those pipes.

In conclusion, it is important that you back yourself up with a great base knowledge of plumbing. Ideally, you were able to find this article both informative and interesting. Use this great information and you will find that you will save a lot of money, as opposed to having to hire a professional.

Back to Top